Long leg = on the base

You will notice the "legs" are offset lengths, the longer leg will contact the base of the board

Start at the nose

Begin applying venom on the nose of the board by splitting the legs and carefully forcing downward onto the edge. Keep tension around the nose and tail sections. Rock and slide the product downward on both sides leaving one bitter end at the waist and the

Hold and FLip

Holding the poduct close to the tail flip your board and apply venom around the tail as seen in the video and meet the other bitter end at the waist. When the product is leading down the boards edge its much easier to apply!

Cut to size

On your first application you will find the venom is longer than the total circumference of your board (this ensures full coverage) you can then cut the excess product to custom fit your board.  Prior to cutting ensure the venom has been applied evenly and with a consistently light tension

finished!

Your snowboard is now ready for transit or storage. Remember, pure silicone is a naturally high friction surface = very grippy. So if you’re having a tough time sliding your VENOM protected board into your board bag, a very small amount of talc/powder on the outside will help

Remember to dry your board completely before storing with venom.

Any water “trapped” between venom and your board’s edge will cause rust.